Vibration motor regulation - vibrating motor - filtration and separation industry

Excitation transferred to 0%. Use the following steps to adjust: A horizontal vibration motor: 1. Relax guard screws, remove both ends of the shield; 2. Excitation is less than MV50-2, MV50-4, MV50-6, MV30-8 of the vibration motor (not included in this four specifications), adjustable eccentric block to block, marked with the largest surface percentage of the ruler exciting force, eccentric block is fixed within the block are compressed using the fastening bolts on the motor shaft. Shaft at both ends of the surface marked with baseline. Loosen the bolts on both sides of the eccentric block, both sides of the same block to rotate the eccentric to axis aligned grooves on the external exciting force eccentric ruler engraved lines, adjusted to the required excitation and tighten the outer eccentric bolts, fitted with protective cover;

3. Excitation is greater than or equal to MV50-2, MV50-4, MV50-6, MV30-8 vibration motors (including the four kinds), a fixed block of the eccentric block, fixed to the shaft with key on, can not rotate. Adjustable eccentric block to block within the outer surface of the exciting force with the largest percentage indicating the benchmark, using the fastening bolts compression in the motor shaft. Loosen the bolts on both sides within the eccentric block, both sides of the same to the rotation within the eccentric block to block within the exciting force eccentric ruler aligned grooves on the outer eccentric slotted, raised to the required excitation, Tighten the inner eccentric bolts, fitted with protective cover;

Note: Except for special applications, the vibration motor shaft at both ends of eccentric position must correspond to both ends of the eccentric block set percentage must be equal opportunity to produce electricity or vibration to the excitation huge mistake, injury motor mechanical vibration.

2, vertical vibration motor: 1. Exciting force of the regulation: Remove the additional block bolts, through the increase or decrease the number of additional blocks to adjust the excitation;

2. The upper and lower eccentric angle adjustment: the eccentric block to a fixed block, the next block is adjustable eccentric blocks are compressed using the fastening bolts on the motor shaft. Shaft at both ends of the surface engraved with baseline, with the outer surface of the next block marked eccentric rotation of the rod, rotating Panasonic eccentric bolts, under the eccentric rotation, so that the next point on the eccentric ruler aligned grooves carved shaft base line, adjusted to the required angle, tighten the bolts under the eccentric; For adjusting the eccentric angle, it can be the appropriate method of regulation.

Third, connect the power The cable vibration motor vibration due to the bear, it should use heavy-duty four-core cable, near the cable exit does not allow a sudden bend, have a 8-9 times greater than the outer diameter of cable bending radius, and then cable fixed to a stationary machine or frame. The distance is about 0.6 m to 0.9 m. Fixed cable clamp office should have a soft pad of insulation material to prevent friction damage cable. 4 core cable grounding wire, one end of the box with the wiring connected to the grounding screw, the other end to be reliable grounding. Small type vibration motor, chassis no junction box, use heavy-duty three-core cable directly from the motor wiring. Feet near the end of the motor is equipped with ground screw, used to be reliable grounding.

Note: Vibration motor outlet cable for the wearing parts, often friction damage due to vibration, resulting in motor missing running, damaged motor. Users should always check the cable situation, if worn should be replaced with the type of cable.

The e-commerce company in China offers quality products such as , and more. For more , please visit china pneumatic equipments today!